OPERATION INSTRUCTIONS :
When move the operation rod , the plunger ( iron core ) will be moved simultaneously so as to make cylinder become under negativepressure . Then , due to closed air pressure of the plank , the grease will get into the cylinder from the suction port . Now , operate the operating rod to extrude out the grease through pipe in the cylinder by principle of the plunger pushing open the specific pressure of 100kg/cm2 , down pressure valve will strart to eturn the grease to the oil tank . The operationg rod is to use of a spring to link on the injeector as a round storage tank to prevent from oil leaking.
ADVANTAGES :
1. Manual type pump . Use of single pipe , so no need of pipe return device . With simple piping for best effect .
2. Has smooth stickness to the lubricating surface with proper oiling capacity , so no surplus oil will be leaked out to stain with the surface of bench .
3. No need to worry about the dirts & impurities entered into the oiling port , so it is more clean than other ways of lubrication.
SPECIFICATION TABLE :
Spec. Oil Outlet Capacity Output Pressure grease distributor max.
SK-224-T03 Grease oil 2 cc / stork 300 cc 100 kg / cm2 SD 60
SK-224-T08 800 cc 100 kg / cm2 SD 60
 
SINGLE CYCLE OIL DISTRIBUTOR ( SD , SD-S(sensor ) )
Max. operating pressure 140 kg / cm2
Recommended grease NLG1 No.00~1
Discharged amount 0.1,0.14,0.18,0.24,0.3
Min. number of ports 3
Max. number of ports 16
SPECIFICATION TABLE :
TYPE A B C D E F G
SD-2,3,4,5,6 ( S ) 35 54 85.9 19 65.9 10.1 19
SD-7,8 ( S ) 35 54 103.2 19 83.2 10.1 19
SD-9,10 ( S ) 35 54 120.5 19 100.5 10.1 19
SD-11,12 ( S ) 35 54 137.8 19 117.8 10.1 19
SD-13,14 ( S ) 35 54 155.1 19 135.1 10.1 19
SD-15,16 ( S ) 35 54 172.4 19 152.4 10.1 19
 
 
 
........................................................................................................................................................................................................
 



FUNCTION AND FEATURES :
1. May or fixed time the TIMER hypothesis and stops the time by PLC for the oil.
2. The high pressure puts out suits the high viscosity fat.
3. Attaches the overload safety valve, may protect the pump and reduce the pipeline damage.
MSK-6 SPECIFICATION TABLE :
Spec. Flow cc/mm Voltage Power Oil Tank Capacity Max.Output Pressure
MSK-601 60 cc/ min 110 V 40 W 1.5L 100 kg / cm2
MSK-602 220 V
MSK-2 SPECIFICATION TABLE :
Spec. Flow cc/mm Voltage Power Oil Tank Capacity Max.Output Pressure
MSK-201 20 cc/ min 110 V 6 W 300 cc / 1.5 L 40 kg / cm2
MSK-202 220 V
MSK-224 24 V
 
 
........................................................................................................................................................................................................